SX1231
WIRELESS & SENSING PRODUCTS
DATASHEET
5.5.7.2. Address Based
Address filtering can be enabled via the AddressFiltering bits. It adds another level of filtering, above Sync word (i.e. Sync
must match first), typically useful in a multi-node networks where a network ID is shared between all nodes (Sync word)
and each node has its own ID (address).
Two address based filtering options are available:
?
?
AddressFiltering = 01 : Received address field is compared with internal register NodeAddress . If they match then the
packet is accepted and processed, otherwise it is discarded.
AddressFiltering = 10 : Received address field is compared with internal registers NodeAddress and BroadcastAddress .
If either is a match, the received packet is accepted and processed, otherwise it is discarded. This additional check with
a constant is useful for implementing broadcast in a multi-node networks
Please note that the received address byte, as part of the payload, is not stripped off the packet and is made available in
the FIFO. In addition, NodeAddress and AddressFiltering only apply to Rx. On Tx side, if address filtering is expected, the
address byte should simply be put into the FIFO like any other byte of the payload.
As address filtering requires a Sync word match, both features share the same interrupt flag SyncAddressMatch .
5.5.7.3. Length Based
In variable length Packet mode, PayloadLength must be programmed with the maximum payload length permitted. If
received length byte is smaller than this maximum then the packet is accepted and processed, otherwise it is discarded.
Please note that the received length byte, as part of the payload, is not stripped off the packet and is made available in the
FIFO.
To disable this function the user should set the value of the PayloadLength to 255.
5.5.7.4. CRC Based
The CRC check is enabled by setting bit CrcOn in RegPacketConfig1 . It is used for checking the integrity of the message.
?
?
On Tx side a two byte CRC checksum is calculated on the payload part of the packet and appended to the end of the
message
On Rx side the checksum is calculated on the received payload and compared with the two checksum bytes received.
The result of the comparison is stored in bit CrcOk.
By default, if the CRC check fails then the FIFO is automatically cleared and no interrupt is generated. This filtering function
can be disabled via CrcAutoClearOff bit and in this case, even if CRC fails, the FIFO is not cleared and only PayloadReady
interrupt goes high. Please note that in both cases, the two CRC checksum bytes are stripped off by the packet handler
and only the payload is made available in the FIFO.
The CRC is based on the CCITT polynomial as shown below. This implementation also detects errors due to leading and
trailing zeros.
Rev. 7 - June 2013
Page 59
www.semtech.com
相关PDF资料
SX1701BI085TRT IC AMP 2.5GHZ 5.3V 16-MLPQ
TA002-10002 LED HEATSINK W/FAN 12V 40X10MM
TC620HEPA IC TEMP SNSR 5V DUAL TRIP 8-DIP
TC623CVOA713 IC TEMP SNSR 3V DUAL TRIP 8-SOIC
TC624VOA IC TEMP SNSR PROG 2.7V 8SOIC
TC6501P125VCTTRG IC TEMP SWTCH OPEN DRAIN SOT23A5
TCS3104FN IC COLOR SENSOR LIGHT-VOLT 4-DFN
相关代理商/技术参数
SX1231H 制造商:SEMTECH 制造商全称:Semtech Corporation 功能描述:Low Power Integrated UHF Transceiver with On-Chip 20dBm PA
SX1231HIMLTRT 制造商:SEMTECH 功能描述:290MHz- 1GHz RF Transceiver
SX1231IMLTRT 制造商:Semtech Corporation 功能描述: 制造商:Semtech Corporation 功能描述:RF Transceiver FSK/GFSK/GMSK/MSK/OOK 3.3V 24-Pin QFN EP T/R 制造商:Semtech Corporation 功能描述:IC 433/868/915MHZ TXRX 24-QFN 制造商:Semtech Corporation 功能描述:SX Series 290 to 1020 MHz 300 Kbps Low Power Integrated UHF Transceiver - QFN-24 制造商:Semtech Corporation 功能描述:GPSS WL SKU APP1, Frequency Min:433MHz, Frequency Max:915MHz, Modulation Type:FS 制造商:Semtech Corporation 功能描述:290MHz- 1GHz RF Transceiver
SX1231ITSTRT 制造商:Semtech Corporation 功能描述:LOW-POWER INTG UHF TRANSCEIVER
SX1231J 制造商:SEMTECH 制造商全称:Semtech Corporation 功能描述:Low Power Integrated UHF Transceiver with On-Chip 20dBm PA
SX1231JIMLTRT 制造商:Semtech Corporation 功能描述:UHF TRANSCEIVER FOR ARIB
SX1231SKB433 制造商:Semtech Corporation 功能描述:
SX1231SKB915 制造商:Semtech Corporation 功能描述:USB KIT - SX1231 915MHZ 制造商:Semtech Corporation 功能描述:development kit